maandag 14 mei 2012

finally some progress

Our PCB is made by the LPKF machine, this week we are going to solder all the components on the PCB. The I2C finally works, I found the error, I used B01000000 (8 bit) as address for the I2C but apparently arduino uses the 7 bit address so B0100000 and adds a '0' or '1' (for write or read) by itself. I also noticed that I made a little mistake in the last schematic of the test setup (the LED was reversed). I changed it in the schematic, below you can see the right one.

here you can see the program code I used for this schematic:

Geen opmerkingen:

Een reactie posten